Homemade Mouse Traps That Work to Kill

Posted on

Most of people prefer mouse trap when they have a problem with mice. this problem is serous, so everyone tries to look for the best homemade mouse trap ever. You can get one easily in a lot of retail stores near your area. However, mouse traps can be a little bit expensive. In this case, the best way is to make the homemade mouse trap. It can be the alternative as it is easy, cheap, and effective with everyday items.

There are many kinds of mouse traps you can make. One of the most favorites is the one in the form of a car. Here is the simple DIY mouse traps no-kill trap for mice & rats that will fix your problem. The first step is supplies. You can use some materials such as a mouse trap, 4 eye hooks, 6 balloons, 2 bic pens, 2 tops from pop cans, some string, and 4 CDs or DVDs. The second step is to strip the pens. All you have to do is to pull the front and back out of the pens. Basically, it is making them hollow the plastic cylinders. The third step is to cut and apply he two balloons. In this step, you have to cut the top and bottom off on two of the balloons first. Then, stretch them over two of the CDs. Later, they will be the back wheels. This will help traction the good deal as CDs are otherwise pretty slippery. The fourth step is to check eye hooks. Keep in mind that the eye hooks are better fit than the pens. The eye hooks need to be loose enough so they can rotate easily. However, do not make it so loose as they can rattle too much. The fifth step is to make a hole. In this step, you just have to make a hole roughly. It is in the center of the one of the pens. You can do it by screwing one of the eye hooks in and ten removing it. apparently, to take the string, it needs to be big enough.


In the sixth step to make a mouse trap car, you will thread the pen. Do it by pushing the string into the pen and get it out one of the sides. The seventh one is to put the eye holes in the trap. Please screw the four eyelets into the mouse trap. Place it along with the short sides. Then, try to get them to be the same depth. This step will make the axle go through them is somewhat straight. Remember to take care to not crack the trap too much. The eighth one is to brace. After doing all of them, the next things you have to do are to make the front wheels, to make the rear axle, to make the back wheels, and then to wind up. when everything is done, the last thing you have to do is to try this tool.

Leave a Reply

Your email address will not be published. Required fields are marked *